M3 Nylon Screw and Standoff Kit (10 Sets, 6mm)

The M3 Nylon Screw and Standoff Kit provides insulated, lightweight mounting hardware designed for securing and stacking printed circuit boards. It is well-suited to students, makers, and robotics hobbyists needing safe component clearance and electrical isolation in compact electronic builds.

Non-conductive electrical insulation

Made from durable nylon, these standoffs isolate circuit boards from chassis surfaces and neighbouring electronics to prevent short circuits. The non-conductive design also helps reduce signal interference across sensitive sensor modules and embedded controllers.

Lightweight and corrosion-resistant hardware

Weighing just 10g in total, this nylon kit provides reliable structural support without adding unnecessary mass to portable devices or compact robots. The material naturally resists oxidation and environmental degradation, ensuring dependable longevity for indoor electronics projects.

Reliable board spacing and stacking

Each 6mm standoff creates consistent clearance for solder joints, connectors, and under-board components. This spacing facilitates organised multi-tier PCB stacking and secure mechanical mounting within enclosures and custom frames.

Complete ten-set fastening pack

The pack includes 10 M3 6mm nylon columns, 10 M3 5mm screws, and 10 matching M3 nuts. This gives you a complete hardware set ready for mounting multiple sensor modules and development boards immediately.

Broad project compatibility

Designed for DIY electronics, educational experiments, and microcontroller prototyping, this hardware fits a wide range of maker setups. It is particularly useful for compact robotics assemblies, sensor arrays, and small embedded systems.