Servo Extension Cable - 150mm

The Servo Extension Cable - 150mm provides extra reach when positioning servo motors away from your main control board. It is an essential component for robotics students, makers, and RC hobbyists building custom chassis or articulated mechanisms.

Extended reach for servo wiring

Measuring 150mm (5.91 inches) in length, this cable extends your wiring harness when a servo is mounted further from the controller than its standard lead reaches.

Standard connector configuration

The cable features a male connector on one end for plugging into your controller and a female connector on the other end to mate directly with the servo lead.

Broad servo compatibility

Designed to suit standard hobby hardware, this extension fits all Hitec, Futaba, JR, Multiplex, and Airtronics Z servos.

Standard colour-coded wiring

The three-wire cable follows standard pinout conventions with red for power (PWR), black for ground (GND), and white for signal.

Dual use as jumper wire

The standard 0.1-inch pin spacing allows this lead to function as a 3-pin jumper cable for general breadboarding and prototyping.

What is included

Each pack contains one 150mm (5.91-inch) servo extension cable.