sheenbot board holder
A holder you print yourself. It keeps five boards in their own slots, and holders clip together end to end, so a whole class set lines up in one row.
Loading the 3D preview…
The boards are sheenbot∞ boards from sheenVerse, at real size. Each holder you add goes on from above, onto the tabs of the one before it.
Drag to turn it. Scroll or pinch to zoom.
STL file, 83 KB. Opens in any slicer.
At a glance
- Holds
- 5 boards, one per slot
- Size
- 96 × 131 × 30 mm
- Joins
- Two tabs at one end, two sockets at the other
- Supports
- None needed
Printing it
Print it the way it opens in your slicer: flat base down on the bed. Nothing overhangs, so it needs no supports.
PLA is fine. The holder only has to carry the boards.
Joining holders
Print as many as you need: each one adds five slots. To join two, hold one above the other and lower its two tabs into the other’s sockets. Joined, they will not pull apart end to end. Lift one straight up to separate them.
The sockets leave a little room around the tabs. If your tabs will not go in, the first layer was probably squashed wider than the rest: trim or sand the bottom edge of the tabs.